GN-807L GNSS Module With Magnetic Compass QMC5883L Support GLONASS Galileo for FPV RC Racing Drone
GN-807L uses multi-constellation GNSS powered by u-b lox M8030-KT芯片设计 is a simultaneous GNSS receiver that can receive and track multiple GNSS systems.
More details about the NEO-M8N, pls check out the U-b lox NEO-M8N page
Specifications
(GPS, GLONASS, Galileo and BeiDou)
Magnetic compass QMC5883L
Patch antenna 25 * 25 * 4mm
Input voltage range: 4 ~ 6V (5V pad / pin)
Power consumption: 50mA
Operating temperatures: -20 ~ 80 ° C
UART (TX, RX) interface for GNSS NEO-M9N
I2C (DA, CL) interface for compass QMC5883L
JST-GH-6P connector
3.3 V power LED, red
GNSS PPS LED, green, flashes (1Hz) when GNSS has 3D fixed
35mm * 35mm * 8.6mm
14.5g
Compass orientation (forward arrow and flat mount):
INAV / BetaFLight: CW 270 ° Flip when flight controller arrow is forward too
Ardupilot / Mission Planner: Rotation None
Protocol: Ub lox or NEMA
Make sure to have compass / magnetometer 10cm away from power lines / ESC / motors / iron based material
The scratches on the ceramic antenna are the result of tuning the antenna.
Product description
GNSS single-frequency multi-system sub-meter positioning moduleGN-807L is a high-performance, multi-system single-frequency GNSS navigation and positioning module, which can simultaneously support receiving GPS, GLONASS, GALILEO and QZSS satellite signals.There are more stars, faster positioning, and higher accuracy. The wide-area differential GPS augmentation system is supported by default. [S129,S137.... Wide-area increase Strong Satellite].
The module has a built-in LNA low-noise amplifier and filtering, a dual-feed point antenna, and a wider bandwidth, so that the signal reception distribution is more even when receiving GNSS satellite signals, so as to achieve more stable signal reception performance and achieve high-precision positioning effects. The module is small in size and light in weight, and can be used in industrial applications such as individuals, vehicles, unmanned aerial vehicles, handheld positioning terminals, and individual positioning systems.
The GN-807L module has the application characteristics of low power consumption, high sensitivity, high precision, and low cost. It is the best choice solution to meet the navigation, positioning, timing, aircraft model and other fields, and can meet the strict application requirements of industrial grade. The GNSS module has a compact size, and the surface adopts a 1.0 6PIN connector and a pad design, which can be more convenient for integration.
GN-807L features
Support GLONASS, GPS, GALILEO, QZSS, SBAS systems (can be set to support Beidou, GPS, BEIDOU, QZSS, SBAS systems) The number of simultaneous tracking satellites is up to 25. Cold start is less than 30s; hot start is less than 2s,
UART/TTL interface with PPS interface
Support refresh rate: 10-15Hz setting, single GPS supports 20HZ output
Built-in 4M fLASH supports setting saving, no data loss when power off.
Timing accuracy: 50ns
Small size: 30x30x8.6mm
LED status indicator, you can observe the module positioning status more intuitively.
Strong anti-interference, anti-multipath effect
Superior quality and reliability
Main application of sub-meter GPS module
Car navigation, personal positioning, drone positioning, synchronization timing, track recording, data acquisition, vehicle monitoring, authorization
Detecting balloons at high altitude.
