GN-2630G GNSS module supports GPS GLONASS Galileo for FPV RC racing droneGN-2630G adopts u-b lox-driven multi-constellation GNSS M8030-KT chip design is a synchronous GNSS receiver that can receive and track multiple GNSS systems.
For more detailed information about NEO-M8N, please check the U-b lox NEO-M8N page
Product features:
UART output protocol
GNSS multi-mode design, support GPS+GLONASS and GPS+ Beidou Positioning mode switching
Built in FLASH can be configured to save output parameters
Using UBX-8030-KT chip design
6PIN pin pad
Baud rate: 9600 (default)
Location mode: GPS+GLONASS (default)
GPS+BEI DOU mode can be set
UBX-M8030-KT chipset
Frequency:
GPS: L1, 1575.4200 MHz
GLONASS: L1, 1602 (k x 0,5625) MHz
BEIDOU COMPASS: B1, 1561.0980 MHz
GALILEO E1, 1575.4200 MHz
QZSS L1, 1575.4200 MHz
Accepts the signals of up to 72 satellites at the same time
Supports AssistNow online / offline,
SBAS (WAAS, EGNOS, QZSS and MSAS)
Supports NMEA 0183 protocols: GGA, GSA, GSV, RMC, VTG
USB specification 2.0
Auto Baud Rate up to 115200 bps
update rate:
Single GNSS: 18 Hz (e.g. GPS solo)
Multi GNSS: 10 Hz (e.g. GPS + GLONASS)
Sensibility max. -167 dBm
Magnetic, non-slip on the bottom
LED-indicator for GPS-status
Operating temperature: -40 ° C to 80 ° C
Power supply: 5 Volt
Current consumption: max. 50mA
Cold start in ca. 26 seconds
Hot start in ca. 1 second
Positioning accuracy: 2.5 m CEP (Circular Error Probable) and
2 m CEP with SBAS
